90° elbow threaded nut M-24X150 to hydraulic pipe Ø 16 outside DIN 2353
- 90º elbow nut nut to hydraulic pipe DIN 2353.- Thread nut nut M-24X150.- For hydraulic pipe Ø 16 outside.- Heavy series.- Material forged steel.- Bichromated anti-oxidation treatment.
11,50 €
90° elbow threaded nut M-22X150 to hydraulic pipe Ø 15 outside DIN 2353
- 90º elbow nut nut to hydraulic pipe DIN 2353.- Thread nut nut M-22X150.- For hydraulic pipe Ø 15 outside.- Light series.- Material forged steel.- Bichromated antioxide treatment.
7,83 €
90° elbow threaded nut M-22X150 to hydraulic pipe Ø 14 outside DIN 2353
- 90º elbow nut nut to hydraulic pipe DIN 2353.- Thread nut nut M-22X150.- For hydraulic pipe Ø 14 outside.- Heavy series.- Material forged steel.- Bichromated anti rust treatment.
10,54 €
90° elbow threaded nut M-20X150 to hydraulic pipe Ø 12 outside DIN 2353
- 90º elbow nut nut to hydraulic pipe DIN 2353.- Thread nut nut M-20X150.- For hydraulic pipe Ø 12 outside.- Heavy series.- Material forged steel.- Bichromated antioxide treatment.
7,13 €
- Air filter. - Height: 125 mm. - Exterior Diameter 128 mm. - Interior Diameter: 64 mm. - Internal Diameter 2: 64 mm. - Weight: 0.540.
25,12 €
90° elbow threaded nut M-36X200 to hydraulic pipe Ø 25 outside DIN 2353
- 90º elbow nut nut to hydraulic pipe DIN 2353.- Thread nut nut M-36X200.- For hydraulic pipe Ø 25 outside.- Heavy series.- Material forged steel.- Bichromated anti rust treatment.
27,25 €
90° elbow threaded nut M-30X200 to hydraulic pipe Ø 22 outside DIN 2353
- 90º elbow nut nut to hydraulic pipe DIN 2353.- Thread nut nut M-30X200.- For hydraulic pipe Ø 22 outside.- Light series.- Material forged steel.- Bichromated anti-oxidation treatment.
15,46 €
90° elbow threaded nut M-30X200 to hydraulic pipe Ø 20 outside DIN 2353
- 90º elbow nut nut to hydraulic pipe DIN 2353.- Thread nut nut M-30X200.- For hydraulic pipe Ø 20 outside.- Heavy series.- Material forged steel.- Bichromated anti rust treatment.
16,75 €
Product features:
Areas of application:
Add Pattex Nural 70, with the stopped motor, by the radiator cap, and if he did not, by the expansion tank making it drop all the granular solid. If the grain is too hard can be softened by adding a little water and by shredding.
Starting the engine until it is hot (minimum time: 30 minutes) and allow to flow the product through the entire circuit, radiator, block, and heating, opening this last for a few minutes.
Tips and tricks:
It is recommended to clean the circuit previously with Pattex Nural 1 and renew the coolant before adding a dose of Pattex Nural 70. Should not withdraw the product after its use.
Use Pattex Nural 70 in circuit with ducts exceeding 0.5 mm step.
Pattex Nural 70 is not suitable to repair leaks above 0.8 mm step.
For any special use or refer to pre - mind with the Technical Support of Henkel.